How to Make a Component Movable

To be able to transfer a component from one unit to another, you have to add the component to one of your Movable component categories. Note that, setting a component as movable is only possible at the office installation of TM Master V2.  Here is how you do it.

1. Start and log on to TM Master V2 at the office using an account with the correct user rights (ref chapter movable user rights).
2. Click [Inventory] → [Components] → Double click the component you wish to turn into a Movable component.
3. Click the “Specification” main tab → Click the “Movable Component” sub-tab, found in the bottom of the “specification” form. (ref image)
4. Tick the “Movable asset” check box.
5. Select the “movable component category” for this component.
6. Click [Save].
7. If the component you configured as movable has any sub components you will be asked to confirm that they too should be made movable. All sub components of the component will be set as “movable”.

This is the “Movable Asset” tab found on the Component specification form.